Preface
About the Editors
PART ONE
NFPA 70E ®, Standard for
Electrical Safety in the Workplace®, with Commentary
Article 90 Introduction
1 Safety-Related Work
Practices
100 Definitions
110 General
Requirements for Electrical Safety- Related Work Practices
120 Establishing an
Electrically Safe Work Condition
130 Work Involving
Electrical Hazards
2 Safety-Related
Maintenance Requirements
200 Introduction
205 General
Maintenance Requirements
210 Substations,
Switchgear Assemblies, Switchboards, Panelboards, Motor Control
Centers, and Disconnect Switches
215 Premises Wiring
220 Controller
Equipment
225 Fuses and
Circuit Breakers
230 Rotating
Equipment
235 Hazardous
(Classified) Locations
240 Batteries and
Battery Rooms
245 Portable
Electric Tools and Equipment
250 Personal Safety
and Protective Equipment
3 Safety Requirements for
Special Equipment
300 Introduction
310 Safety-Related
Work Practices for Electrolytic Cells
320 Safety
Requirements Related to Batteries and Battery Rooms
330 Safety-Related
Work Practices for Use of Lasers
340 Safety-Related
Work Practices: Power Electronic Equipment
350 Safety-Related
Work Requirements: Research and Development Laboratories
Annexes
A Referenced
Publications
B Informational
References
C Limits of
Approach
D Incident Energy
and Flash Protection Boundary Calculation Methods
E Electrical Safety
Program
F Hazard/Risk
Evaluation Procedure
G Sample Lockout/Tagout
Procedure
H Simplified,
Two-Category, Flame-Resistant (FR) Clothing System
I Job Briefing and
Planning Checklist
J Energized
Electrical Work Permit
K General
Categories of Electrical Hazards
L Typical
Application of Safeguards in the Cell Line Working Zone
M Layering of
Protective Clothing and Total System Arc Rating
N Example
Industrial Procedures and Policies for Working Near Overhead
Electrical Lines and Equipment
O Safety-Related
Design Requirements
PART TWO
Supplements
1 Electrical
Preventive Maintenance Programs
2 Safe Electrical
Installations
Index
Important Notices and
Legal Disclaimers